![]() ![]() For surface plate work or just general checking a ways on a lathe or mill, what focal length should I be looking for? Again, I see no specs on any of these units.ģ. Are they in fact DC and what are the pin inputs on the MIL plugs I see?Ģ. I'm assuming these are DC, but have found no specs on any online. Power supply: I see a couple of Hiligar and Watts one or two without a power supply. I don't need laser nor anything fancy.Īny suggested brands and hints would be appreciated. Would like to spend less than $1K if possible. ![]() In any case, I've recently gotten interested in purchasing an older autocollimator, as much to learn about them as to use for my own purposes in machine setup, surface plate checking, etc. I've been lurking around for a couple of years, learning from those of you who are much more knowledgeable than I. I'm a hobby machinist primarily doing my own small projects, prototyping, etc. ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |